At Morreston, we provide a bespoke pipe repair service within our Pipework Fabrication and Installation Service. 

Our mechanical engineering solution provides a range of solutions for your pipework, from on-site pipe welding repairs and section renewals to hot tapping, pipe freezing services, pipe repair services, & pipe restoration services. 

Pipes have many uses, they provide water, heat, chemicals and power, and on some occasions, they will need to be repaired. There are several reasons why they need repairing. It could be due to corrosion, a shear break, a deflected pipe or even a joint break. All of these can be caused by ground movement or other bending forces, with shear breaks due to the pipes splitting in two.  

Pipework repairs can be pretty costly but considerably cheaper than having to replace your systems. Depending on the condition of your pipes, our experienced pipe contractors are trained to the highest standards possible; we will provide an onsite visit to inspect the condition of your pipes and fault find until we can provide a solution. 

In many cases, pipe repairs need to be undertaken in extreme conditions and within strict time constraints. Our pipe repairs service considers all of these factors without the need for a costly, time-consuming, and disruptive shutdown of power.

Combined with our fabrication and installation service, we also design, manufacture & install a range of pipework solutions. From initial inspection, we provide a complete turnkey solution for a whole host of industrial & commercial pipework requirements.  

Our Pipework service ranges from complete site installation service to one-off single spools UK wide and is broken down by: 

• Initial survey and discussions

• Prefabrication works off-site

• Crane operations

• Site installation

• Water treatment of installed systems

• Flow measurement/commissioning services 

To find out more about our bespoke solutions, get in touch with the team for further information